aJile Prototyping

Discussion about designs based on the aJ-100 processor

aJile Prototyping

Postby VRMAD1 » Tue Oct 23, 2007 12:05 am

I'm looking for a cheap way to mount aj-100 chips for prototyping. Frys sells some vector boards with a raised solder mask that can be used to manually solder chips to the surface. Since I don't have surface mount soldering capabilities I was wondering if anyone has any other suggestions. The Frys solution doesn't say if it will work on LQFP packages. It also looks like it requires a very steady hand while soldering.

Here's what the Fry's board looks like. I need to mount two chips per prototype system. As far as I know, the aj-100 is not offered in packages that can be socketed.


Thanks in advance!
Dan Johnson, Skype: VRMAD1
Web sites - http://EpicenterTech.biz , http://vrmad.EpicenterTech.biz
E-mail: vrmad1@gmail.com
AIM: VRMAD1, ISPQ: VRMAD1, 2nd Life: Gladje (39,183,26), There.com: VRMAD1
Posts: 2
Joined: Thu Sep 27, 2007 1:12 am
Location: Lexington, Kentucky

Return to aJ-100

Who is online

Users browsing this forum: No registered users and 1 guest